IO Level Converter Breakout 4Channel/8Channel

Description

8 Channel IO Level Converter Breakout

Connect your Raspberry Pi, Arduino, or 3.3V/5V device to 5-24V signals safely. Complete isolation Great for level shifting from 5V to 3.3V as well.

Are you looking to connect a microcontroller, Raspberry Pi, or Arduino to high-voltage or loud signals? Look nowhere else! – This 4-channel & 8-channel input opt isolator board produces clean, regulated 3.3-5V signals on the output side and accepts nominal voltages of 5­-24V (maximum of 40V) on the input side. A LOW/grounded state fed into an input will result in a LOW/wrecked state on the output, and vice versa.

• This board is simply because of its big screw terminals, obvious LED state indicators, and optional 2.54mm headers.
• High Voltage (HV) inputs are located on both sides of the board and range in voltage from 5 to 24 VDC.
• Low Voltage (LV) outputs are between 3.3 and 5 volts of direct current.

Directions

• To the HVIN pin on the HV INPUT side, connect your HV power supply.
• The HVGND pin on the HV INPUT side is connected to the HV ground.
• Connect your LV power source to the LVIN pin on the LV OUTPUT side.
• Your LV ground should be connected to the LVGND pin on the LV Output side.
• Any HV output signals should be connected to pins 1 through 8 on the HV INPUT side.

Absolute Maximum Scores

• HVIN Supply Voltage: 5 to 24 VDC
• LVIN Supply Voltage is 3.3 to 6 VDC.
• 5 kHz is the signal frequency.
• C1/C1+/C2 Verified Compatible With Raspberry Pi 1/2/3 Arduino Beaglebone Black/Green

Additional information